2014 Hilux · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. REMOVE REAR WHEEL

2. REMOVE REAR PROPELLER SHAFT ASSEMBLY
  1. for TSAM Made:
    (Click here)

  1. for TMT Made:
    (Click here)


3. DRAIN DIFFERENTIAL OIL

  1. for front differential:

    1. Stop the vehicle on a level surface.

    2. A272242E01
      Using SST and the 10 mm straight hexagon wrench, 10 mm union nut wrench and socket adaptor, remove the differential filler plug and gasket.
      SST
      09961-00950  
      Text in Illustration 
      *1
      10 mm Straight Hexagon Wrench
      *2
      10 mm Union Nut Wrench
      *3
      Socket Adaptor

    3. Remove the drain plug and gasket, and drain the oil.

    4. Install a new gasket and the drain plug.

      Torque:
      65 N*m{ 660 kgf*cm , 48 ft.*lbf }

  1. for rear differential:

    1. Stop the vehicle on a level surface.

    2. Remove the differential filler plug and gasket.

    3. Remove the drain plug and gasket, and drain the oil.

    4. Install a new gasket and the drain plug.

      Torque:
      49 N*m{ 500 kgf*cm , 36 ft.*lbf }


4. REMOVE REAR AXLE SHAFT WITH BACKING PLATE LH
(Click here)

5. REMOVE REAR AXLE SHAFT WITH BACKING PLATE RH

HINT:
Use the same procedure described for the LH side.


6. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

C236646
  1. Remove the 10 nuts and differential carrier.

    NOTICE:
    Be careful not to damage the contact surface.


7. REMOVE REAR DIFFERENTIAL CARRIER GASKET
← COMPONENTS (from Jun 2011)DISASSEMBLY (from Jun 2011) →