REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. REMOVE REAR WHEEL |
| 2. REMOVE REAR PROPELLER SHAFT ASSEMBLY |
for TSAM Made:
(Click here)
for TMT Made:
(Click here)
| 3. DRAIN DIFFERENTIAL OIL |
for front differential:
Stop the vehicle on a level surface.
Using SST and the 10 mm straight hexagon wrench, 10 mm union nut wrench and socket adaptor, remove the differential filler plug and gasket.

- SST
- 09961-00950
Text in Illustration *1
10 mm Straight Hexagon Wrench
*2
10 mm Union Nut Wrench
*3
Socket Adaptor
Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
- Torque:
- 65 N*m{ 660 kgf*cm , 48 ft.*lbf }
for rear differential:
Stop the vehicle on a level surface.
Remove the differential filler plug and gasket.
Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
- Torque:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }
| 4. REMOVE REAR AXLE SHAFT WITH BACKING PLATE LH |
| 5. REMOVE REAR AXLE SHAFT WITH BACKING PLATE RH |
- HINT:
- Use the same procedure described for the LH side.
| 6. DISCONNECT REAR DIFFERENTIAL LOCK ACTUATOR BREATHER TUBE |
Disconnect the rear differential lock actuator breather tube.

Disconnect the 2 connectors.
| 7. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY |
Remove the 11 nuts and differential carrier.

- NOTICE:
- Be careful not to damage the contact surface.
| 8. REMOVE REAR DIFFERENTIAL CARRIER GASKET |
