2014 Hilux · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.


2. REMOVE CONSOLE BOX ASSEMBLY
(Click here)

3. REMOVE SHIFT LEVER BOOT ASSEMBLY

  1. G034215E03
    Remove the 4 screws, 2 clips and shift lever boot.


4. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

G021695E01
  1. Cover the shift lever cap with a cloth.

  1. Press down on the shift lever cap and rotate it counterclockwise to remove it.

  1. Pull out the shift lever.


5. REMOVE ENGINE UNDER COVER

6. REMOVE NO. 1 ENGINE UNDER COVER

7. DRAIN MANUAL TRANSMISSION OIL
  1. Remove the drain plug and gasket to drain the oil.

  1. Install a new gasket and the drain plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


8. REMOVE NO. 2 CROSSMEMBER SUB-ASSEMBLY

D033401E01
  1. Remove the 4 bolts, 4 nuts and frame crossmember.


9. REMOVE REAR PROPELLER SHAFT ASSEMBLY
for TSAM made: (Click here)
for TMT made: (Click here)

10. REMOVE FRONT EXHAUST PIPE ASSEMBLY
for 2KD-FTV: (Click here)
for 1TR-FE: (Click here)

11. DISCONNECT WIRE HARNESS
  1. Disconnect the back-up light switch connector and speedometer sensor connector.


12. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

G034217E01
  1. Remove the 2 bolts and disconnect the release cylinder assembly.


13. REMOVE STARTER ASSEMBLY
for 2KD-FTV for 2.0 kW Type: (Click here)
for 2KD-FTV for 2.2 kW Type: (Click here)
for 1TR-FE for 1.0 kW Type: (Click here)
for 1TR-FE for 1.7 kW Type: (Click here)

14. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

B085193E03
  1. Support the transmission rear side with a support stand.

  1. Remove the 4 set bolts of the No. 1 engine mounting insulator rear.

  1. Remove the 4 bolts, 4 nuts and frame crossmember.


15. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

G034219E04
  1. Remove the 4 bolts and mounting insulator.


16. REMOVE EXHAUST MANIFOLD STAY (1TR-FE)

B086194E01
  1. Remove the 3 bolts and exhaust manifold stay.


17. REMOVE STIFFENER PLATE (2KD-FTV)

G034607E01
  1. Remove the 4 bolts and stiffener plate RH.

  1. Remove the 4 bolts and stiffener plate LH.


18. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY

G039485E01
  1. Using a transmission jack, support the transmission.

  1. Remove the support stand from the rear side.

  1. 2KD-FTV:
    Remove the 5 bolts and transmission.

  1. 1TR-FE:
    Remove the 7 bolts and transmission.

← COMPONENTS (from Jun 2011)REMOVAL (Aug 2012 – Jul 2013) →