HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Jun 2011 – Jul 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
- HINT:
- Use these procedures to troubleshoot the power window control system.
- *1: w/o Regulator
- *2: w/ Regulator
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
Refer to the Problem Symptoms Table (Click here).
Result
Result
|
Proceed to
|
Fault is not listed in problem symptoms table
|
A
|
Fault is listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 4.OVERALL ANALYSIS AND TROUBLESHOOTING |
Operation Check (Click here).
Terminals of ECU (Click here).
| NEXT |
|
 |
|
|
Result
Result
|
Proceed to
|
Door window regulator replaced or removed/installed (w/ Jam Protection)
|
A
|
Door window regulator not replaced or removed/installed (w/ Jam Protection)
|
B
|
Vehicles without a jam protection function
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 6.RESET FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER SIDE)*1 OR FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (FOR DRIVER SIDE)*2 |
w/o Regulator:
If the power window regulator master switch light is blinking, reset the front power window regulator motor assembly (for driver side) (Click here).
w/ Regulator:
If the power window regulator master switch light is blinking, reset the front door window regulator sub-assembly (for driver side) (Click here).
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|