2014 Hilux · Service Manual BODY

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

HINT:
Use these procedures to troubleshoot the power window control system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).

    2. Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B

    B.
    A

    4.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Operation Check (Click here).

    2. Terminals of ECU (Click here).

    NEXT

    5.REPAIR OR REPLACE
      Result 
      Result
      Proceed to
      Door window regulator replaced or removed/installed (w/ Jam Protection)
      A
      Door window regulator not replaced or removed/installed (w/ Jam Protection)
      B
      Vehicles without a jam protection function
      B

    B.
    A

    6.PERFORM INITIALIZATION
    1. w/o Regulator:

      1. Initialize the front power window regulator motor assembly (for driver side) (Click here).

    2. w/ Regulator:

      1. Initialize the front door window regulator sub-assembly (for driver side) (Click here).

    NEXT

    7.CONFIRMATION TEST
      NEXT

      ← HOW TO PROCEED WITH TROUBLESHOOTING (Jun 2011 – Jul 2013)OPERATION CHECK (from Jun 2011) →