2014 Hilux · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE REAR SEAT CUSHION ASSEMBLY LH (for Extra Cab)

  1. B288340
    Operate the rear seat cushion lock hook release lever and pull up the rear seat cushion assembly LH to detach the hook.
    Text in Illustration 
    V100135
    Pull Up
    V100136
    Release

  1. B288341
    Detach the 2 hooks and rear seat cushion assembly LH.


4. REMOVE REAR SEAT CUSHION ASSEMBLY RH (for Extra Cab)

HINT:
Use the same procedures described for the LH side.


5. REMOVE REAR SEAT ASSEMBLY (for Double Cab)
  1. Remove the rear seat assembly (Click here).


6. REMOVE QUARTER INSIDE TRIM BOARD LH (for Extra Cab)

B113105
  1. Remove the bolt and anchor.

  1. B114992
    Remove the bolt and rear No. 1 seat belt anchor.

  1. Remove quarter inside trim board (Click here).


7. REMOVE REAR SEAT ASSEMBLY (for Double Cab)

B276874
  1. Pull the rear seat hinge cover LH to detach the 2 claws.

    Text in Illustration 
    V100135
    Pull
    V100136
    Pull Up

  1. Pull up the rear seat hinge cover LH to detach the guide and remove the rear seat hinge cover LH.


8. REMOVE REAR DOOR SCUFF PLATE LH (for Double Cab)

B277892E01
  1. Put protective tape around the rear door scuff plate LH.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 7 claws and 2 clips, and remove the rear door scuff plate LH.


9. REMOVE REAR DOOR OPENING TRIM LH (for Double Cab)

10. REMOVE QUARTER TRIM PANEL LOWER LH (for Double Cab)

B276982
  1. w/o Rear Center Seat Belt:

    1. Detach the claw and 3 clips and remove the lower quarter trim panel LH.

  1. B353738
    w/ Rear Center Seat Belt:

    1. Detach the claw and 3 clips and remove the lower quarter trim panel LH.


11. REMOVE REAR NO. 1 SEAT BELT ASSEMBLY OUTER LH

B089293E04
  1. Remove the bolt and floor anchor.

  1. B086292E13
    Using a screwdriver, detach the 2 claws and open the seat belt anchor cover.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt.

  1. B113849E01
    Remove the bolt and seat belt.

← REMOVAL (Aug 2012 – Jul 2013)INSPECTION (from Jun 2011) →