B158F AV Signal Stoppage (Low Battery Voltage)
Diagnostic trouble codes · Vehicles built from Aug 2013
DESCRIPTION
This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the navigation receiver assembly dropping temporarily.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B158F |
A video or audio signal is interrupted when the battery voltage drops. |
Navigation receiver assembly |
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK VEHICLE SIGNAL (OPERATION CHECK) |
Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).

Check that the battery voltage.
- Standard voltage:
- 11 to 14 V
- HINT:
- This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.
|
|
||||
| OK | |
| 2. CHECK FOR DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check that no DTCs are output (Click here).
- OK:
- No DTCs are output.
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY POWER SOURCE) |
Disconnect the navigation receiver assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
N12-4 (B) - Body ground
Always
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Navigation Receiver Assembly)
|
|
||||
| OK | ||
| ||
