P0627 Fuel Pump Control Circuit / Open
Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
Refer to SYSTEM DESCRIPTION (Click here).| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0627 |
Open or short in suction control valve circuit for more than 0.5 seconds (1 trip detection logic) |
|
- HINT:
- For more information on the supply pump (suction control valve) and the common rail system, refer to the system description (Click here).
- When DTC P0627 is set, check the internal fuel pressure of the common rail by entering the following menus on the intelligent tester: Powertrain / Engine / Data List / Fuel Press.
- For more information on the supply pump (suction control valve) and the common rail system, refer to the system description (Click here).
- Reference:
Engine Speed
Fuel Pressure
Idling
Approximately 25000 to 35000 kPa
3,000 rpm (No engine load)
Approximately 50000 to 70000 kPa
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
| 1. INSPECT SUPPLY PUMP ASSEMBLY (SUCTION CONTROL VALVE) |
Disconnect the S8 suction control valve connector.

Measure the resistance of the suction control valve.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
1.9 to 2.3 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (SUCTION CONTROL VALVE - ECM) |
Disconnect the S8 suction control valve connector.

Disconnect the E8 ECM connector.
Measure the resistance of the wire harness side connector.
- Standard resistance (Check for open):
Tester Connection
Specified Condition
S8-1 - PCV+ (E8-2)
Below 1 Ω
S8-2 - PCV- (E8-1)
- Standard resistance (Check for short):
Tester Connection
Specified Condition
S8-1 or PCV+ (E8-2) - Body ground
10 kΩ or higher
S8-2 or PCV- (E8-1) - Body ground
|
|
||||
| OK | |
| 3. INSPECT ECM (PCV VOLTAGE) |
Inspect using the oscilloscope.

During cranking or idling, check the waveform between the specified terminals of the E8 ECM connector.
- Standard:
Tester Connection
Specified Condition
PCV+ (E8-2) - PCV- (E8-1)
Correct waveform is as shown
|
|
||||
| OK | ||
| ||
