The air conditioning amplifier assembly monitors signals from the speedometer sensor via the combination meter assembly. The air conditioning amplifier assembly uses these signals to adjust the thermistor signal.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
Check that the speedometer in the combination meter assembly operates normally before inspecting the speedometer malfunction (Click here).
1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
Remove the air conditioning amplifier assembly with its connectors still connected (Click here).
Using an oscilloscope, check the waveform of the air conditioning amplifier assembly.
Measurement Condition
Item
Content
Tester Connection
A44-9 (SPD) - Body ground
Tool Setting
5 V/DIV., 20 ms./DIV.
Condition
Driving at approximately 20 km/h (12 mph)
OK:
Waveform is as shown in the illustration.
Text in Illustration
*a
Component with harness connected (Air Conditioning Amplifier Assembly)
HINT:
As the vehicle speed increases, the wavelength becomes shorter.
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
2. CHECK COMBINATION METER ASSEMBLY
Remove the combination meter assembly with its connector still connected (Click here).
Connect an oscilloscope to the combination meter assembly connector.
Check the waveform.
Measurement Condition
Item
Content
Tester Connection
C8-6 - Body ground
Tool setting
5 V/DIV., 20 ms./DIV.
Condition
Vehicle is driven at approximately 20 km/h (12 mph)
OK:
Waveform is as shown in the illustration.
Text in Illustration
*a
Component with harness connected (Combination Meter Assembly)
HINT:
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.