2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

Vehicle Speed Signal Circuit

Circuit diagnosis · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

CAUTION / NOTICE / HINT


DESCRIPTION

The air conditioning amplifier assembly monitors signals from the speedometer sensor via the combination meter assembly. The air conditioning amplifier assembly uses these signals to adjust the thermistor signal.

WIRING DIAGRAM

E225335E03

INSPECTION PROCEDURE

HINT:
Check that the speedometer in the combination meter assembly operates normally before inspecting the speedometer malfunction (Click here).


1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY

  1. E170958E07
    Remove the air conditioning amplifier assembly with its connectors still connected (Click here).

  1. Using an oscilloscope, check the waveform of the air conditioning amplifier assembly.

    Measurement Condition 
    Item
    Content
    Tester Connection
    A44-9 (SPD) - Body ground
    Tool Setting
    5 V/DIV., 20 ms./DIV.
    Condition
    Driving at approximately 20 km/h (12 mph)

    OK:
    Waveform is as shown in the illustration.

    Text in Illustration 
    *a
    Component with harness connected
    (Air Conditioning Amplifier Assembly)

    HINT:
    As the vehicle speed increases, the wavelength becomes shorter.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK COMBINATION METER ASSEMBLY

  1. E224591E07
    Remove the combination meter assembly with its connector still connected (Click here).

  1. Connect an oscilloscope to the combination meter assembly connector.

  1. Check the waveform.

    Measurement Condition 
    Item
    Content
    Tester Connection
    C8-6 - Body ground
    Tool setting
    5 V/DIV., 20 ms./DIV.
    Condition
    Vehicle is driven at approximately 20 km/h (12 mph)

    OK:
    Waveform is as shown in the illustration.

    Text in Illustration 
    *a
    Component with harness connected
    (Combination Meter Assembly)

    HINT:
    When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (COMBINATION METER - AIR CONDITIONING AMPLIFIER)
  1. Disconnect the C8 combination meter assembly connector.

  1. Disconnect the A44 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C8-6 - A44-9 (SPD)
    Always
    Below 1 Ω
    A44-9 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)


← Vehicle Speed Signal Circuit (Jun 2011 – Jul 2012)Vehicle Speed Signal Circuit (from Aug 2013) →