2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use these procedures to troubleshoot the air conditioning system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
      NEXT

      3.INSPECT BATTERY VOLTAGE
      1. Measure the voltage of the battery.

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      NEXT

      4.CHECK FOR DTC*
      1. Check for DTCs and note any codes that are output (Click here).

      2. Clear the DTCs (Click here).

      3. Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the conditions indicated by the DTC. Then recheck for DTCs.

        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      A

      5.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      A

      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Terminals of ECU (Click here)

      2. Data list / Active test (Click here)

      3. On-vehicle Inspection

      4. Inspection

      NEXT

      7.ADJUST, REPAIR OR REPLACE
        NEXT

        8.CONFIRMATION TEST
          NEXT

          ← HOW TO PROCEED WITH TROUBLESHOOTING (Jun 2011 – Jul 2012)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2013) →