Reverse Signal Circuit
Circuit diagnosis · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly*1 or back-up light switch assembly*2.- *1: for Automatic Transmission
- *2: for Manual Transmission
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE) |
Enter the "Function Check/Setting I" mode and select "Vehicle Signal" (Click here).

Check that the display changes between ON and OFF according to the shift lever position.
- OK:
Shift Lever Position
Display
R
ON
Except R
OFF
- HINT:
- This display is updated once per second. As a result, it is normal for the display to lag behind the actual shift lever position.
|
|
||||
| OK | ||
| ||
| 2. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY |
Disconnect the R21 radio and display receiver assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
R21-2 (REV) - Body ground
Ignition switch ON, shift lever in R
7.5 to 14 V
R21-2 (REV) - Body ground
Ignition switch ON, shift lever not in R
Below 1 V
Text in Illustration *a
Front view of wire harness connector
(to Radio and Display Receiver Assembly)
Result Result
Proceed to
OK
A
NG (for Automatic Transmission)
B
NG (for Manual Transmission)
C
|
|
||||
|
|
||||
| A | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY) |
Disconnect the R21 radio and display receiver assembly connector.
Disconnect the N8 park/neutral position switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R21-2 (REV) - N8-1 (RL)
Always
Below 1 Ω
R21-2 (REV) - Body ground
Always
10 kΩ or higher
Result Result
Proceed to
OK (for A340E)
A
OK (for A340F)
B
OK (for A750E)
C
OK (for A750F)
D
NG
E
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
| 4. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BACK-UP LIGHT SWITCH ASSEMBLY) |
Disconnect the R21 radio and display receiver assembly connector.
Disconnect the B1 back-up light switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R21-2 (REV) - B1-1
Always
Below 1 Ω
R21-2 (REV) - Body ground
Always
10 kΩ or higher
Result Result
Proceed to
OK (for R150 / R151 / R156)
A
OK (for R151F / R156F)
B
NG
C
|
|
||||
|
|
||||
| A | ||
| ||
