B1579 Voice Recognition Microphone Disconnected
Diagnostic trouble codes · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013
DESCRIPTION
Microphone signal from the telephone microphone assembly is sent to the radio and display receiver assembly.Also, power is supplied from the radio and display receiver assembly to the telephone microphone assembly.
If microphone signal is disconnected, this DTC is stored.
This DTC is stored when a malfunction occurs in a connected device.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1579 |
Telephone microphone signal is lost. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- For vehicles equipped with an Extension Module, refer to optional equipment's manuals.
| 1. CHECK MICROPHONE (OPERATION CHECK) |
Enter the "Microphone & Voice Recognition Check" screen (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

- OK:
- Check result is normal.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - MAP LIGHT) |
Disconnect the R21 radio and display receiver assembly connector.
Disconnect the M6 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R21-4 (MACC) - M6-4 (MACC)
Always
Below 1 Ω
R21-5 (MIN+) - M6-3 (MCO+)
R21-19 (MIN-) - M6-2 (MCO-)
R21-6 (SNS2) - Body ground
R21-4 (MACC) - Body ground
Always
10 kΩ or higher
R21-5 (MIN+) - Body ground
R21-19 (MIN-) - Body ground
R21-18 (SGND) - Body ground
|
|
||||
| OK | |
| 3. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
R21-18 (SGND) - Body ground
Always
Below 1 Ω
R21-19 (MIN-) - Body ground
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
R21-4 (MACC) - Body ground
Ignition switch ACC
4 to 6 V
| *a |
Component with harness connected (Radio and Display Receiver Assembly) |
|
|
||||
| OK | |
| 4. REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK |
Replace the telephone microphone with a normal one (Click here).
Check if the same problem occurs again.
- OK:
- Malfunction disappears.
|
|
||||
| OK | ||
| ||
