2014 Hilux · Service Manual BODY ELECTRICAL

B1579 Voice Recognition Microphone Disconnected

Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013

DESCRIPTION

Microphone signal from the telephone microphone assembly is sent to the radio and display receiver assembly.
Also, power is supplied from the radio and display receiver assembly to the telephone microphone assembly.
If microphone signal is disconnected, this DTC is stored.
This DTC is stored when a malfunction occurs in a connected device.
DTC Code
DTC Detection Condition
Trouble Area
B1579
Telephone microphone signal is lost.
  1. Map light assembly (telephone microphone assembly)
  2. Radio and display receiver assembly

WIRING DIAGRAM

C240174E14

INSPECTION PROCEDURE

HINT:
For vehicles equipped with an Extension Module, refer to optional equipment's manuals.


1. CHECK MICROPHONE (OPERATION CHECK)
  1. Enter the "Microphone & Voice Recognition Check" screen (Click here).

  1. E222013
    When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

    OK:
    Check result is normal.



NG
Go to step 2
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)

2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - MAP LIGHT)
  1. Disconnect the R21 radio and display receiver assembly connector.

  1. Disconnect the M6 map light assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R21-4 (MACC) - M6-4 (MACC)
    Always
    Below 1 Ω
    R21-5 (MIN+) - M6-3 (MCO+)
    R21-19 (MIN-) - M6-2 (MCO-)
    R21-6 (SNS2) - Body ground
    R21-4 (MACC) - Body ground
    Always
    10 kΩ or higher
    R21-5 (MIN+) - Body ground
    R21-19 (MIN-) - Body ground
    R21-18 (SGND) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

  1. E199613E15
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R21-18 (SGND) - Body ground
    Always
    Below 1 Ω
    R21-19 (MIN-) - Body ground

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R21-4 (MACC) - Body ground
    Ignition switch ACC
    4 to 6 V

Text in Illustration 
*a
Component with harness connected
(Radio and Display Receiver Assembly)


NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK


4. REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK
  1. Replace the telephone microphone with a normal one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE MAP LIGHT ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)


← B1550 DAB Tuner Malfunction (+ 6 more codes) (Aug 2012 – Jul 2013)B1579 Voice Recognition Microphone Disconnected (Aug 2012 – Jul 2013) →