Home › Engine / Hybrid System › 2TR-FBE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › from 2012.10
RM1840EF _51 Engine / Hybrid System _009576 2TR-FBE ENGINE MECHANICAL _0052198 REAR CRANKSHAFT OIL SEAL A

2TR-FBE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

Hide 4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 5.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

a.
G038108
2.25,1.583 2.25,1.854 false 1.333,1.479 0.844,1.479 false 2.135,1.875 2.615,2.135 0.479,0.26 10 false SST 0.51,1.385 0.99,1.688 0.479,0.302 10 false SST

Using SST, hold the crankshaft.

SST
09213-54015  (91651-60855)
09330-00021  


b.
A252562

Remove the 10 bolts and flywheel.


Hide 6.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

a.
G038108
2.25,1.583 2.25,1.854 false 1.333,1.479 0.844,1.479 false 2.135,1.875 2.615,2.135 0.479,0.26 10 false SST 0.51,1.385 0.99,1.688 0.479,0.302 10 false SST

Using SST, hold the crankshaft.

SST
09213-54015  (91651-60855)
09330-00021  


b.
A252563

Remove the 10 bolts, rear drive plate spacer, drive plate and front drive plate spacer.


Hide 7.REMOVE REAR CRANKSHAFT OIL SEAL

a.
A252564
1.052,1.948 0.938,1.948 0.938,1.948 0.688,1.573 true 1.74,1.146 2.427,1.948 2.427,1.948 2.552,1.948 true 1.083,1.854 1.271,2.021 0.188,0.167 10 false *1 2.625,1.844 2.813,2.01 0.188,0.167 10 true *2
*1 Cut Position
*2 Protective Tape


Using a knife, cut off the lip of the oil seal.


b.

Using a screwdriver, pry out the oil seal.

NOTICE:
·

Do not damage the surface of the oil seal press fit hole or the crankshaft.

·

After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.



HINT:

Tape the screwdriver tip before use.