When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.DRAIN ENGINE COOLANT
4.REMOVE DIESEL THROTTLE BODY ASSEMBLY
5.DISCONNECT NO. 3 WATER BY-PASS HOSE
6.DISCONNECT NO. 4 WATER BY-PASS HOSE
7.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY
8.REMOVE NO. 2 INTAKE AIR CONNECTOR BRACKET
9.DISCONNECT NO. 3 WATER BY-PASS PIPE
10.REMOVE ELECTRIC VACUUM REGULATING VALVE ASSEMBLY
11.REMOVE NO. 2 INTAKE AIR CONNECTOR
12.REMOVE INTAKE AIR CONNECTOR
13.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER
14.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY
15.REMOVE EGR VALVE ADAPTER
16.REMOVE NO. 2 EGR VALVE ASSEMBLY
17.REMOVE EGR COOLER