Home › Engine / Hybrid System › 2KD-FTV INTAKE / EXHAUST › EXHAUST MANIFOLD W/ TURBOCHARGER(w/o EGR Cooler) › 2012.01–2012.04
RM1840EF _51 Engine / Hybrid System _009590 2KD-FTV INTAKE / EXHAUST _0052339 EXHAUST MANIFOLD W/ TURBOCHARGER(w/o EGR Cooler) A

2KD-FTV INTAKE / EXHAUST  EXHAUST MANIFOLD W/ TURBOCHARGER(w/o EGR Cooler)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 4.REMOVE NO. 2 ENGINE UNDER COVER

Hide 5.REMOVE FRONT WHEEL RH

Hide 7.REMOVE FRONT FENDER APRON SEAL UPPER

a.

Remove the 5 clips and front fender apron seal upper.


Hide 8.REMOVE FRONT FENDER SEAL

a.

Remove the 5 clips and front fender seal.


Hide 9.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ No. 1 Engine Cover)

Hide 10.REMOVE VENTILATION HOSE HEAT INSULATOR

a.

Remove the 2 bolts and ventilation hose heat insulator.


Hide 11.REMOVE AIR CLEANER ASSEMBLY

a.
A252009

w/ Mass Air Flow Meter:

Disconnect the mass air flow meter connector and detach the wire harness clamp.


b.
A110353

w/o Mass Air Flow Meter:

Detach the clamp and disconnect the intake air temperature sensor connector.


c.

Loosen the hose clamp, and then remove the air cleaner hose from the turbocharger.


d.

Disconnect the ventilation hose and remove the 2 bolts and air cleaner.


Hide 13.REMOVE TURBINE OUTLET ELBOW

A099515

a.

Remove the 2 bolts, 4 nuts, turbine outlet elbow (with turbocharger stay) and gasket from the turbocharger.


b.

Remove the 2 bolts and turbocharger stay from the turbine outlet elbow.


Hide 14.REMOVE TURBOCHARGER SUB-ASSEMBLY

A098783

a.

Remove the 2 bolts and manifold stay.


b.

Remove the 2 bolts, union bolt and 2 gaskets.


c.
A098784

Remove the 3 nuts, turbocharger (with turbo oil pipe) and gasket.


d.
A110356

Remove the 2 nuts, turbo oil pipe and gasket from the turbocharger.


Hide 15.REMOVE EXHAUST MANIFOLD

a.
A252011

Remove the 8 nuts, 8 plate washers and exhaust manifold as shown in the illustration.