1.INSTALL THERMOSTAT
| *1 | Gasket |
| *2 | Jiggle Valve |
| *a | CORRECT |
| *b | INCORRECT |
|
Upward |
Install a new gasket to the thermostat.
When installing the gasket to the thermostat, be careful not to deform the gasket. Make sure that the groove of the gasket is properly installed to the thermostat as shown in the illustration.
Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.
The jiggle valve may be set within 30° of either side of the prescribed position.
2.INSTALL WATER INLET
Install the wire harness clamp bracket to the water inlet with the bolt.
Install the water inlet with the 3 bolts.
Connect the wire harness clamp.
3.CONNECT RADIATOR HOSE OUTLET
Connect the radiator hose outlet to the water inlet.
4.CONNECT NO. 1 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP (for Automatic Transmission)
Connect the No. 1 automatic transmission oil cooler tube clamp to the water inlet with the bolt.
5.INSTALL COMPRESSOR INLET ELBOW (w/ DPF)
6.INSTALL COMPRESSOR INLET ELBOW (w/o DPF)
7.INSTALL AIR CLEANER ASSEMBLY
8.INSTALL VENTILATION PIPE
9.ADD ENGINE COOLANT
10.INSPECT FOR COOLANT LEAK
11.INSTALL INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR
w/ Glow Plug Controller: (See page Engine / Hybrid System>1KD-FTV INTAKE / EXHAUST>INTERCOOLER(w/ Glow Plug Controller)>INSTALLATION)
w/o Glow Plug Controller: (See page Engine / Hybrid System>1KD-FTV INTAKE / EXHAUST>INTERCOOLER(w/o Glow Plug Controller)>INSTALLATION)
12.INSTALL NO. 1 ENGINE UNDER COVER