When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1.INSTALL WATER PUMP ASSEMBLY
Install a new gasket and the water pump with the 5 bolts and 2 nuts.
2.INSTALL NO. 2 TIMING BELT COVER
3.INSTALL CAMSHAFT TIMING PULLEY
4.INSTALL NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
5.INSTALL TIMING BELT
6.INSTALL NO. 1 TIMING BELT COVER
7.INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
8.INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY
9.INSTALL NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY
10.INSTALL V-RIBBED BELT TENSIONER ASSEMBLY
11.INSTALL GENERATOR BRACKET
12.INSTALL GENERATOR ASSEMBLY
13.INSTALL NO. 2 IDLE PULLEY ASSEMBLY
14.CONNECT COOLER COMPRESSOR ASSEMBLY
15.INSTALL FAN SHROUD
Install the fan pulley to the water pump.
Install the fan shroud together with the fluid coupling with fan between the radiator and engine component.
Be careful not to damage the radiator core.
Install the fluid coupling with fan to the fan pulley with the 4 nuts.
Tighten the nuts as much as possible by hand.
Attach the claws of the fan shroud to the radiator.
Install the fan shroud with the 2 bolts.
Install the fan and generator V belt (See page Engine / Hybrid System>2KD-FTV ENGINE MECHANICAL>DRIVE BELT>INSTALLATION).
Tighten the 4 nuts of the fluid coupling with fan.
Install the radiator reservoir with the 2 bolts.
Connect the No. 1 and No. 2 water by-pass hoses to the radiator.
Install the oil reservoir with the 3 bolts.
16.INSTALL RADIATOR HOSE INLET
17.INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER (w/ EGR Cooler)
18.INSTALL INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR (w/ EGR Cooler)
19.INSTALL NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY (w/o EGR Cooler)
20.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
21.BLEED AIR FROM FUEL SYSTEM
22.ADD ENGINE COOLANT
23.INSPECT FOR COOLANT LEAK
24.INSPECT FOR FUEL LEAK
25.INSPECT FOR OIL LEAK
26.INSTALL NO. 1 ENGINE UNDER COVER