Home › Engine / Hybrid System › 2KD-FTV COOLING › THERMOSTAT › from 2012.10
RM1840EF _51 Engine / Hybrid System _009595 2KD-FTV COOLING _0052373 THERMOSTAT A

2KD-FTV COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 1.INSTALL THERMOSTAT

a.
A301805
1.552,1.073 1.552,1.188 false 2.75,1.115 2.75,1.229 false 1.323,3.604 2.333,3.604 true 1.479,0.448 1.792,0.646 0.313,0.198 10 false *a 2.688,0.458 3,0.656 0.313,0.198 10 false *b 1.469,1.24 1.781,1.438 0.313,0.198 10 false *1 2.677,1.24 2.99,1.438 0.313,0.198 10 false *1 2.438,3.521 2.75,3.719 0.313,0.198 10 false *2 1.021,3.135 1.354,3.333 0.333,0.198 10 false 30° 1.385,3.135 1.719,3.333 0.333,0.198 10 false 30°
*1 Gasket
*2 Jiggle Valve
*a CORRECT
*b INCORRECT
V100135

Upward


Install a new gasket to the thermostat.

NOTICE:

When installing the gasket to the thermostat, be careful not to deform the gasket. Make sure that the groove of the gasket is properly installed to the thermostat, as shown in the illustration.



b.

Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.

HINT:

The jiggle valve may be set within 30° of either side of the prescribed position.



Hide 2.INSTALL WATER INLET

a.

Install the wire harness clamp bracket to the water inlet with the bolt.

Torque:
13 N*m (128 kgf*cm, 9 ft.*lbf)


b.

Install the water inlet with the 3 bolts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


c.

Connect the wire harness clamp.


Hide 3.CONNECT RADIATOR HOSE OUTLET

a.

Connect the radiator hose outlet to the water inlet.


Hide 12.INSTALL NO. 1 ENGINE UNDER COVER (for 4WD and Pre-Runner)