Home › Engine / Hybrid System › 2KD-FTV COOLING › WATER PUMP(w/ DPF) › from 2012.10
RM1840EF _51 Engine / Hybrid System _009595 2KD-FTV COOLING _0052375 WATER PUMP(w/ DPF) A

2KD-FTV COOLING  WATER PUMP(w/ DPF)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes, clean them with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 5.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER

Hide 6.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 7.REMOVE NO. 2 CYLINDER HEAD COVER SUB-ASSEMBLY

Hide 8.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

Hide 9.REMOVE RADIATOR HOSE INLET

Hide 10.REMOVE FAN SHROUD

a.
A110387

Remove the 3 bolts and oil reservoir.


b.
A252176

Disconnect the No. 1 and No. 2 water by-pass hoses from the radiator.


c.

Remove the 2 bolts and radiator reservoir.


d.

Loosen the 4 nuts holding the fluid coupling with fan.


e.

Remove the fan and generator V belt (See page Engine / Hybrid System>2KD-FTV ENGINE MECHANICAL>DRIVE BELT>REMOVAL).


f.

Remove the 2 bolts holding the fan shroud.


g.

Remove the 4 nuts of the fluid coupling with fan, and then remove the fan shroud together with the fluid coupling with fan.

NOTICE:

Be careful not to damage the radiator core.



h.

Remove the fan pulley from the engine water pump.


Hide 11.DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)

Hide 21.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A252180
2.26,1.5 2.323,1.563 false
V100135

Bolt
V100136

Nut


Remove the 5 bolts, 2 nuts, engine water pump and gasket.