When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE NO. 1 ENGINE UNDER COVER
4.DRAIN ENGINE COOLANT
5.DRAIN ENGINE OIL
6.REMOVE INTAKE MANIFOLD
7.REMOVE GLOW PLUG ASSEMBLY
8.REMOVE INJECTOR ASSEMBLY
9.REMOVE COMMON RAIL ASSEMBLY
10.REMOVE TURBOCHARGER SUB-ASSEMBLY
11.REMOVE FAN SHROUD
12.DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)
13.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System)
14.REMOVE EXHAUST MANIFOLD
15.REMOVE TIMING BELT
16.REMOVE CAMSHAFT TIMING PULLEY
Remove the bolt of the camshaft timing pulley while holding the camshaft with a wrench.
Make sure the timing belt is not installed when removing the bolt of the camshaft timing pulley.
Remove the camshaft timing pulley.
17.REMOVE NO. 2 TIMING BELT COVER
Remove the 4 bolts, nut and No. 2 timing belt cover.
18.REMOVE CYLINDER BLOCK INSULATOR
Remove the cylinder block insulator from the cylinder head.
19.REMOVE CAMSHAFT
| *1 | Key Groove |
Turn the camshaft with a wrench so that the key groove of the camshaft faces upward.
Uniformly loosen the 15 bearing cap bolts in several passes in the sequence shown in the illustration.
Remove the 15 bearing cap bolts, 5 bearing caps, oil seal and 2 camshafts.
20.REMOVE VALVE LIFTER
21.REMOVE CYLINDER HEAD SUB-ASSEMBLY
Uniformly loosen the 18 cylinder head bolts in several passes in the sequence shown in the illustration. Then remove the 18 cylinder head bolts and 18 washers.
Head warpage or cracking could result from removing bolts in the incorrect order.
Lift the cylinder head from the dowels on the cylinder block, and place the cylinder head on wooden blocks on a bench.
Be careful not to damage the contact surfaces of the cylinder head and cylinder block.
If the cylinder head is difficult to lift, use a screwdriver to pry between the cylinder head and block.
22.REMOVE CYLINDER HEAD GASKET