Home › Engine / Hybrid System › 2TR-FBE COOLING › RADIATOR › 2011.10–2012.10
RM1840EF _51 Engine / Hybrid System _009596 2TR-FBE COOLING _0052380 RADIATOR A

2TR-FBE COOLING  RADIATOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL RADIATOR ASSEMBLY

a.

Install the radiator with the 4 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


b.

w/ Airbag System:

i.

Attach the 4 clamps to the radiator.



Hide 2.CONNECT OIL COOLER INLET HOSE (for Automatic Transmission)

a.

Connect the oil cooler inlet hose to the radiator.


Hide 3.CONNECT OIL COOLER OUTLET HOSE (for Automatic Transmission)

a.

Connect the oil cooler outlet hose to the radiator.


Hide 4.INSTALL FAN SHROUD

A099679
3.031,1.375 3.24,1.573 0.208,0.198 10 A

a.

Install the fan pulley to the engine water pump.


b.

Place the shroud together with the fluid coupling fan between the radiator and engine.

NOTICE:

Be careful not to damage the radiator core.



c.

Install the coupling fan to the water pump with the 4 nuts. Tighten the nuts as much as possible by hand.


d.

Attach the shroud's claws to the radiator as shown in A in the illustration.


e.

Install the fan shroud with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


f.

Connect the reservoir hose to the radiator tank upper.


g.

Install the fan and generator V belt (See page Engine / Hybrid System>2TR-FBE ENGINE MECHANICAL>DRIVE BELT>INSTALLATION).


h.

Tighten the 4 nuts of the fluid coupling fan.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 6.CONNECT RADIATOR HOSE INLET

a.

Connect the radiator hose inlet to the radiator.


Hide 7.CONNECT RADIATOR HOSE OUTLET

a.

Connect the radiator hose outlet to the radiator.


Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 11.INSTALL RADIATOR SIDE DEFLECTOR LH

a.

Install the radiator side deflector with the 3 clips and attach the claw.


Hide 12.INSTALL RADIATOR SIDE DEFLECTOR RH

a.

Install the radiator side deflector with the 3 clips and attach the claw.