1.DRAIN TRANSFER OIL
2.REMOVE LOWER TRANSFER CASE PROTECTOR
Remove the 4 bolts and lower transfer case protector.
3.REMOVE FRONT PROPELLER SHAFT ASSEMBLY
4.REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
5.REMOVE TRANSFER CASE OIL SEAL
Using SST, tap out the transfer case oil seal.
Be careful not to damage the oil seal and front case contact surface.
6.INSTALL TRANSFER CASE OIL SEAL
Coat the lip of a new oil seal with MP grease.
Using SST and a hammer, tap in the oil seal until its metal ring contacts the case.
7.INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
8.INSTALL FRONT PROPELLER SHAFT ASSEMBLY
9.INSTALL LOWER TRANSFER CASE PROTECTOR
Install the protector with the 4 bolts.
10.ADD TRANSFER OIL
11.CHECK FOR TRANSFER OIL LEAK