Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY › from 2012.10
RM1840EF _52 Drivetrain _009617 DRIVE SHAFT / PROPELLER SHAFT _0052544 FRONT DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT DRIVE SHAFT HOLE SNAP RING

a.

Install a new hole snap ring.


Hide 2.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

F042771

a.

Coat the splines of the inboard joint with differential oil.


b.

Align the splines and tap in the drive shaft with a brass bar and hammer.

HINT:

Whether or not the inboard joint shaft is in contact with the pinion shaft can be determined from the sound and feeling when tapping in the shaft.


NOTICE:
·

Make sure that the snap ring opening is facing downwards when installing the drive shaft.

·

Be careful not to damage the oil seal, boot or dust cover.




Hide 5.CONNECT TIE ROD END SUB-ASSEMBLY LH

Hide 8.INSTALL FRONT WHEEL

Torque:
105 N*m (1071 kgf*cm, 77 ft.*lbf)