1.REMOVE NO. 1 ENGINE UNDER COVER
2.REMOVE NO. 2 ENGINE UNDER COVER
3.DRAIN DIFFERENTIAL OIL
4.REMOVE FRONT PROPELLER SHAFT ASSEMBLY
5.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
6.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
Use the same procedure described for the LH side.
7.REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY
Remove the bolt and disconnect the differential breather tube bracket.
Support the differential with a jack.
| *1 | Mounting Bolt |
| *2 | Mounting Nut |
Remove the No. 1 differential mounting nut.
Remove the 2 mounting bolts and 2 nuts.
Lower the jack and remove the front differential.
Remove the 3 bolts and front No. 1 differential support.
Remove the 2 mount stoppers from the differential support.
Remove the 2 bolts and front No. 2 differential support.
Remove the 2 bolts and front No. 3 differential support.