Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.REMOVE NO. 1 ENGINE UNDER COVER
3.REMOVE NO. 2 ENGINE UNDER COVER
4.DRAIN DIFFERENTIAL OIL
5.REMOVE FRONT AXLE HUB GREASE CAP
6.REMOVE FRONT AXLE SHAFT NUT
7.DISCONNECT FRONT SPEED SENSOR LH (w/ ABS)
8.DISCONNECT TIE ROD END SUB-ASSEMBLY LH
9.DISCONNECT FRONT LOWER SUSPENSION ARM ASSEMBLY LH
10.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Using SST, remove the front drive shaft.
Be careful not to damage the oil seal.
Keep the drive shaft level while handling it.
Be careful not to drop the front drive shaft.
11.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING
Using a screwdriver, remove the snap ring.