Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY(w/ Differential Lock) › from 2012.10
RM1840EF _52 Drivetrain _009618 AXLE AND DIFFERENTIAL _0052572 REAR DIFFERENTIAL CARRIER ASSEMBLY(w/ Differential Lock) A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY(w/ Differential Lock)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

a.

Clean the contact surfaces of the differential carrier and axle housing.

NOTICE:

Be careful not to damage the installation surface.



b.

Install the differential carrier and a new gasket with the 10 nuts and washers.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

NOTICE:

Be careful to install the gasket without tearing it.



Hide 2.CONNECT REAR DIFFERENTIAL LOCK ACTUATOR BREATHER TUBE

a.

Connect the rear differential lock actuator breather tube.


b.

Connect the 2 connectors.


Hide 3.INSTALL REAR AXLE SHAFT WITH BACKING PLATE LH

Hide 4.INSTALL REAR AXLE SHAFT WITH BACKING PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 8.ADJUST PARKING BRAKE