1.INSTALL BRAKE BOOSTER ASSEMBLY
Install a new gasket to the brake booster.
Install the booster with the 4 nuts.
Install the push rod clevis.
Apply a light coat of lithium soap base glycol grease to the clevis pin.
| *1 | Brake Pedal Return Spring |
| *2 | Clevis Pin |
| *3 | Clip |
Install the clevis pin and a new clip.
The clip must be installed as shown in the illustration.
Install the return spring.
Install the vacuum check valve grommet and vacuum check valve to the brake booster.
Connect the vacuum hose.
Install the vacuum warning switch grommet to the brake booster.
Install the vacuum warning switch to the brake booster and connect the vacuum warning switch connector.
2.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD
3.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
4.BLEED BRAKE SYSTEM
5.BLEED CLUTCH LINE (for Manual Transmission)
6.CHECK AND ADJUST BRAKE PEDAL HEIGHT