1.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (for Double Cab)
Attach the 8 clamps to install the antenna cord.
Connect the 2 connectors.
2.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY (for Extra Cab)
Attach the 11 clamps to install the antenna cord.
Make sure the cable of the antenna passes behind pin A.
Connect the 2 connectors.
3.INSTALL ROOF HEADLINING ASSEMBLY
for Extra Cab:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Extra Cab)>INSTALLATION)
for Double Cab:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>INSTALLATION)
4.INSTALL ANTENNA CORD SUB-ASSEMBLY
w/ Roof Antenna:
Install the antenna cord with the clamp bolt.
Attach the 5 clamps.
Connect the connector.
w/o Roof Antenna:
Attach the 4 clamps shown in the illustration to install the antenna cord.
Connect the connector.
5.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
7.CHECK SRS WARNING LIGHT