Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM(w/ VSC) › from 2012.10
RM1840EF _57 Power Source / Network _009639 NETWORKING _0052677 CAN COMMUNICATION SYSTEM(w/ VSC) T

NETWORKING  CAN COMMUNICATION SYSTEM(w/ VSC)  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Result of CAN V Bus Check
Symptom Suspected Area Link
Open in CAN Main Wire CAN Main Bus Line Click here
Short in CAN Bus Lines CAN Bus Line Click here
Short to B+ in CAN Bus Line CAN Bus Line Click here
Short to GND in CAN Bus Line CAN Bus Line Click here
Open in One Side of CAN Branch Line CAN Branch Line Click here

HINT:

Refer to How to Proceed with Troubleshooting for the CAN V bus check procedure.


Communication Stop Mode Table
Symptom Suspected Area Link
"Skid Control (ABS/VSC/TRAC)" is not displayed on the intelligent tester Skid Control ECU Communication Stop Mode Click here
"Spiral cable (Steering Angle Sensor)" is not displayed on the intelligent tester Steering Angle Sensor Communication Stop Mode Click here
"Yaw Rate Sensor" is not displayed on the intelligent tester Yaw Rate Sensor Communication Stop Mode Click here
"ECM (Engine)" is not displayed on the intelligent tester ECM Communication Stop Mode Click here