Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM › from 2012.10
RM1840EF _58 Vehicle Interior _009641 THEFT DETERRENT / KEYLESS ENTRY _0052689 ENGINE IMMOBILISER SYSTEM S

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


Engine Immobiliser System
DTC No. Detection Item Note Link
B2780 Push Switch / Key Unlock Warning Switch Malfunction
DTC Output Confirmation Operation

Insert the key into the ignition key cylinder.


Click here
B2784 Antenna Coil Open / Short
Detection Enabling Condition (DTC Output Confirmation Operation)

Insert the key into the ignition key cylinder.


Click here
B2793 Transponder Chip Malfunction
Detection Enabling Condition (DTC Output Confirmation Operation)

Insert the key into the ignition key cylinder.


Click here
B2794 Unmatched Encryption Code
Detection Enabling Condition (DTC Output Confirmation Operation)

Insert the key into the ignition key cylinder.


Click here
B2795 Unmatched Key Code
Detection Enabling Condition (DTC Output Confirmation Operation)

Insert the key into the ignition key cylinder.


Click here
B2796 No Communication in Immobiliser System
Detection Enabling Condition (DTC Output Confirmation Operation)

Insert the key into the ignition key cylinder


Click here
B2797 Communication Malfunction No. 1
Detection Enabling Condition (DTC Output Confirmation Operation)

Insert the key into the ignition key cylinder


Click here
B2798 Communication Malfunction No. 2
Detection Enabling Condition (DTC Output Confirmation Operation)

Insert the key into the ignition key cylinder


Click here
B2799 Engine Immobiliser System Malfunction
Detection Enabling Condition (DTC Output Confirmation Operation)

Either condition is met:


·

Within 10 seconds of an engine start operation being performed (with the shift lever in P and the brake pedal [for Automatic Transmission] or clutch pedal [for Manual Transmission] depressed, turn the ignition switch to ON). If there is a malfunction, the engine stops (communication begins within 3 seconds of the engine start operation being performed, and DTCs are stored after 6 seconds).

·

10 seconds after the ignition switch is turned to ON after reconnecting the cable to the negative (-) battery terminal (communication begins within 3 seconds of the ignition switch being turned to ON, and DTCs are stored after 6 seconds).


Click here
B279A Theft Deterrent System Communication Line High Fixation
Detection Enabling Condition (DTC Output Confirmation Operation)

Turn the ignition switch to ON and wait 6 seconds.


Click here
B279C Theft Deterrent System Presence Detection
Detection Enabling Condition (DTC Output Confirmation Operation)

Check for DTCs.


Click here