Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL QUARTER WINDOW WEATHERSTRIP RH
Install the quarter window weatherstrip RH.
2.INSTALL QUARTER WINDOW HINGE RH
Install the 2 quarter window hinges, 2 bushes, 2 quarter window hinge retainers and 2 washers with the 2 screws.
3.INSTALL QUARTER WINDOW LOCK ASSEMBLY RH
Install the quarter window lock assembly RH, bush and quarter window hinge retainer with the screw.
4.INSTALL QUARTER WINDOW GLASS RH
Install the quarter window assembly RH with the 2 bolts.
Install the 2 bolts.
5.CHECK FOR LEAKS AND REPAIR
6.INSTALL INNER UPPER ROOF SIDE GARNISH RH
Attach the 3 clips to install the inner upper roof side garnish RH.
7.INSTALL QUARTER PILLAR GARNISH RH
Attach the 2 clips to install the quarter pillar garnish RH.
Connect the front seat belt shoulder anchor with the bolt.
Attach the 4 claws to install the front seat belt anchor cover cap.
8.INSTALL QUARTER INSIDE TRIM BOARD RH
Attach the 7 clips, 3 guides and 4 claws to install the quarter inside trim board RH.
Connect the front seat outer belt floor anchor with the bolt.
9.INSTALL LOWER BACK PANEL GARNISH
10.INSTALL REAR SEAT ASSEMBLY
11.INSTALL FRONT DOOR OPENING TRIM RH
12.INSTALL FRONT DOOR SCUFF PLATE RH
Attach the 4 clips and 8 claws to install the front door scuff plate.
13.INSTALL FRONT SEAT ASSEMBLY RH
for Bench Seat Type
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>INSTALLATION)
for Separate Seat Type
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Separate Seat Type)>INSTALLATION)