Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2012.01–2012.04
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052601 VEHICLE STABILITY CONTROL SYSTEM T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



NOTICE:

When replacing the brake actuator assembly, a sensor, etc., turn the ignition switch off.


Vehicle Stability Control System
Symptom Suspected Area Link
ABS, BA and/or EBD does not operate Check for DTCs again and make sure that the normal system code is output Click here
IG power source circuit (low power supply voltage malfunction) Click here
IG power source circuit (high power supply voltage malfunction) Click here
Front speed sensor circuit (open or short malfunction) Click here
Front speed sensor circuit (output malfunction) Click here
Rear speed sensor circuit (open or short malfunction) Click here
Rear speed sensor circuit (output malfunction) Click here
Check the brake actuator assembly with the intelligent tester (check brake actuator assembly operation using the Active Test function). If abnormal, check the hydraulic circuit for leaks. Click here
If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) Click here
ABS, BA and/or EBD does not operate efficiently Check for DTCs again and make sure that the normal system code is output Click here
Front speed sensor circuit (open or short malfunction) Click here
Front speed sensor circuit (output malfunction) Click here
Rear speed sensor circuit (open or short malfunction) Click here
Rear speed sensor circuit (output malfunction) Click here
Stop light switch circuit Click here
Check the brake actuator assembly with the intelligent tester (check brake actuator assembly operation using the Active Test function). If abnormal, check the hydraulic circuit for leaks. Click here
If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) Click here
ABS sensor DTC check cannot be performed Check for DTCs again and make sure that the normal system code is output Click here
TC and CG terminal circuit Click here
If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) Click here
ABS warning light abnormal (Remains on) Refer to ABS Warning Light Remains ON Click here
ABS warning light abnormal (Does not come on) Refer to ABS Warning Light does not Come ON Click here
Brake warning light abnormal (Remains on) Refer to Brake Warning Light Remains ON Click here
Brake warning light abnormal (Does not come on) Refer to Brake Warning Light does not Come ON Click here
VSC and/or TRC does not operate Check for DTCs again and make sure that the normal system code is output Click here
IG power source circuit (low power supply voltage malfunction) Click here
IG power source circuit (high power supply voltage malfunction) Click here
Check the hydraulic circuit for leaks -
Front speed sensor circuit (open or short malfunction) Click here
Front speed sensor circuit (output malfunction) Click here
Rear speed sensor circuit (open or short malfunction) Click here
Rear speed sensor circuit (output malfunction) Click here
Yaw rate and acceleration sensor circuit (zero point malfunction) Click here
Yaw rate and acceleration sensor circuit (power supply malfunction) Click here
Yaw rate sensor circuit (comparison malfunction) Click here
Steering angle sensor circuit (zero point malfunction) Click here
Steering angle sensor circuit (output malfunction) Click here
If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) Click here
VSC sensor DTC check cannot be performed Check for DTCs again and make sure that the normal system code is output Click here
TC and CG terminal circuit Click here
If the symptoms still occur even after the above items in the suspected area column have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly) Click here
VSC OFF indicator light abnormal (Remains on) Refer to VSC OFF Indicator Light Remains ON Click here
VSC OFF indicator light abnormal (Does not come on) Refer to VSC OFF Indicator Light does not Come ON Click here
Slip indicator light abnormal (Remains on) Refer to Slip Indicator Light Remains ON Click here
Slip indicator light abnormal (Does not come on) Refer to Slip Indicator Light does not Come ON Click here
Test Mode (signal check) cannot be performed TS and CG terminal circuit Click here
Skid control ECU (Brake actuator assembly) Click here