LIGHTING SYSTEM > Headlight Beam Level Control Actuator Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (HEADLIGHT LEVELING MOTOR) |
Using the intelligent tester, perform the Active Test (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Drive The Leveling Motor UP | Leveling motor | ON/OFF | - |
| Drive The Leveling Motor DOWN | Leveling motor | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (HEADLIGHT UNIT - HEADLIGHT LEVELING ECU ASSEMBLY) |
Disconnect the H27 headlight leveling ECU connector.
Disconnect the H23*1 or H22*2 headlight leveling motor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H27-11 (LH+) - H23-3 (LHB1) | Always | Below 1 Ω |
| H27-18 (LHE) - H23-2 (LHM+) | Always | Below 1 Ω |
| H27-24 (LH-) - H23-1 (LH E) | Always | Below 1 Ω |
| H27-11 (LH+) - Body ground | Always | 10 kΩ or higher |
| H27-18 (LHE) - Body ground | Always | 10 kΩ or higher |
| H27-24 (LH-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| H27-10 (RH+) - H22-3 (RHB1) | Always | Below 1 Ω |
| H27-17 (RHE) - H22-2 (RHM+) | Always | Below 1 Ω |
| H27-23 (RH-) - H22-1 (RH E) | Always | Below 1 Ω |
| H27-10 (RH+) - Body ground | Always | 10 kΩ or higher |
| H27-17 (RHE) - Body ground | Always | 10 kΩ or higher |
| H27-23 (RH-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HEADLIGHT UNIT (OPERATION) |
Temporarily replace the headlight unit (headlight leveling motor) with a new or normally functioning one (Click here).
Perform the Active Test of the leveling motors.
|
| ||||
| OK | ||
| ||