AUTOMATIC TRANSMISSION ASSEMBLY (for 1KD-FTV) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. DRAIN AUTOMATIC TRANSMISSION FLUID |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 4. DRAIN TRANSFER OIL |
| 5. INSTALL CONSOLE BOX ASSEMBLY |
| 6. REMOVE SHIFT LEVER BOOT ASSEMBLY |
![]() |
Remove the 4 screws and shift lever boot.
| 7. REMOVE TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY |
Fold back the transfer front drive shift boot.
![]() |
Using needle-nose pliers, remove the snap ring and pull out the shift lever.
| 8. REMOVE NO. 1 ENGINE UNDER COVER |
| 9. REMOVE NO. 2 ENGINE UNDER COVER |
| 10. REMOVE EXHAUST PIPE |
| 11. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
| 12. REMOVE PROPELLER SHAFT ASSEMBLY |
| 13. DISCONNECT OIL COOLER TUBE |
![]() |
Using a union nut wrench, disconnect the tube outlet and tube inlet.
![]() |
Remove the 3 bolts and 3 clamps.
| 14. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Remove the nut and clip and disconnect the control cable.
| 15. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET |
![]() |
Remove the 2 bolts and control cable bracket from the transmission.
| 16. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY |
![]() |
Support the transmission with a transmission jack.
| 17. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
Remove the 4 set bolts of the rear No. 1 engine mounting insulator.
Remove the 4 nuts, 4 bolts and frame crossmember.
| 18. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR |
![]() |
Remove the 4 bolts and rear No. 1 engine mounting insulator from the automatic transmission.
| 19. DISCONNECT WIRE HARNESS |
![]() |
Remove the nut and disconnect the ground cable.
![]() |
Tilt the transmission downward.
Disconnect the 8 connectors and detach the 7 clamps.
Remove the bolt and disconnect the wire harness.
| 20. REMOVE STARTER ASSEMBLY |
| 21. REMOVE STIFFENER PLATE |
![]() |
| *A | LH Side |
| *B | RH Side |
Remove the 4 bolts and stiffener plate RH (with oil cooler tube clamp).
Remove the 4 bolts and stiffener plate LH.
Remove the No. 4 cylinder block insulator.
Remove the end plate.
| 22. REMOVE DRIVE PLATE AND TORQUE CONVERTER SETTING BOLT |
![]() |
Turn the crankshaft to gain access to the 6 torque converter setting bolts and remove each bolt through the hole of the flywheel while holding the crankshaft pulley bolt with a wrench.
| 23. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY |
![]() |
Remove the 5 bolts.
Remove the automatic transmission assembly.
| 24. REMOVE TRANSFER ASSEMBLY |
Remove the 8 bolts and 2 clamps.
Remove the transfer from the transmission.
| 25. REMOVE TORQUE CONVERTER ASSEMBLY |