Home › ENGINE ยท 1KD-FTV › INTAKE › TURBOCHARGER

TURBOCHARGER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE INTERCOOLER ASSEMBLY
  1. w/ Glow Plug Controller: (Click here)
  2. w/o Glow Plug Controller: (Click here)


4. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


5. REMOVE FRONT WHEEL RH


6. REMOVE NO. 1 ENGINE UNDER COVER


7. REMOVE NO. 2 ENGINE UNDER COVER


8. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



    A099591E01
  1. Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.



  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A112147E01



9. REMOVE FRONT FENDER APRON SEAL UPPER
  1. Remove the 5 clips and front fender apron seal upper.



10. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and front fender seal.



11. REMOVE AIR CLEANER ASSEMBLY
  1. Disconnect the mass air flow meter connector.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner.



12. REMOVE VENTILATION PIPE


    A211832
  1. Remove the bolt and disconnect the 2 ventilation hoses and ventilation pipe.



13. REMOVE COMPRESSOR INLET ELBOW


    A211833
  1. Disconnect the 2 connectors from the turbocharger.

  1. Detach the wire harness clamp.

  1. Remove the 2 nuts, compressor inlet elbow and gasket.



14. REMOVE NO. 1 TURBO INSULATOR


    A255740
  1. Remove the 2 bolts and No. 1 turbo insulator.



15. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A255741
  1. Remove the bolt and No. 1 exhaust manifold heat insulator.



16. REMOVE NO. 1 TURBO WATER HOSE


    A211835
  1. Remove the 2 No. 1 turbo water hoses.



17. REMOVE TURBINE OUTLET ELBOW


    A211836
  1. Remove the 3 nuts, turbine outlet elbow and gasket.



18. REMOVE TURBOCHARGER STAY


    A211837
  1. Remove the 2 bolts, nut and turbocharger stay.



19. REMOVE TURBO OIL INLET PIPE SUB-ASSEMBLY


    A098817E03
  1. Remove the 2 bolts, 2 nuts, union bolt, turbo oil inlet pipe and 3 gaskets.

    NOTICE:
    Do not loosen the nut labeled A.



20. REMOVE TURBOCHARGER SUB-ASSEMBLY


    A211839
  1. Remove the 3 nuts, turbocharger and gasket.



21. REMOVE NO. 1 TURBO WATER PIPE SUB-ASSEMBLY


    A211906
  1. Remove the 2 nuts, bolt, No. 1 turbo water pipe and gasket.