DTC P0201 Injector Circuit / Open - (Cylinder 1) |
DTC P0202 Injector Circuit / Open - (Cylinder 2) |
DTC P0203 Injector Circuit / Open - (Cylinder 3) |
DTC P0204 Injector Circuit / Open - (Cylinder 4) |
DTC P062D No. 1 Fuel Injector Driver Circuit Performance |

| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Idling for 5 seconds | Open or short in injector circuit occurs a certain number of times (a maximum of approx. 0.5 seconds). (1 trip detection logic) |
|
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Idling for 5 seconds | Inconsistency in the injection waveforms between the injector driver and ECM while the engine is running a certain number of times (a maximum of approx. 0.5 seconds). (1 trip detection logic) |
|



| 1.CHECK ENGINE CRANKING CONDITION |
Check the engine cranking condition.
| Result | Proceed to |
| Engine does not start*1 | A |
| Engine starts, but idling is rough*2 | B |
| Except above | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT ECM |
![]() |
Check the waveform of the ECM connectors using an oscilloscope.
| Tester Connection | Condition | Specified Condition |
| E29-21 (#1) - E28-6 (E1) | Cranking | Correct waveform is as shown |
| E29-22 (#2) - E28-6 (E1) | Cranking | Correct waveform is as shown |
| E29-23 (#3) - E28-6 (E1) | Cranking | Correct waveform is as shown |
| E29-24 (#4) - E28-6 (E1) | Cranking | Correct waveform is as shown |
| *a | Component with harness connected (ECM) |
|
| ||||
| OK | |
| 3.CHECK TERMINAL VOLTAGE INJECTOR DRIVER POWER SOURCE |
![]() |
Disconnect the injector driver connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I17-2 (+B) - I17-4 (GND) | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Injector Driver) |
Reconnect the injector driver connectors.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (INJECTOR DRIVER - ECM) |
Disconnect the injector driver connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I19-7 (#10) - E29-21 (#1) | Always | Below 1 Ω |
| I19-3 (#20) - E29-22 (#2) | Always | Below 1 Ω |
| I19-6 (#30) - E29-23 (#3) | Always | Below 1 Ω |
| I19-4 (#40) - E29-24 (#4) | Always | Below 1 Ω |
| I19-8 (INJF) - E29-20 (INJF) | Always | Below 1 Ω |
| I19-7 (#10) or E29-21 (#1) - Body ground | Always | 10 kΩ or higher |
| I19-3 (#20) or E29-22 (#2) - Body ground | Always | 10 kΩ or higher |
| I19-6 (#30) or E29-23 (#3) - Body ground | Always | 10 kΩ or higher |
| I19-4 (#40) or E29-24 (#4) - Body ground | Always | 10 kΩ or higher |
| I19-8 (INJF) or E29-20 (INJF) - Body ground | Always | 10 kΩ or higher |
Reconnect the injector driver connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 5.REPLACE INJECTOR DRIVER |
Replace the injector driver (Click here).
|
| ||||
| 6.CHECK WHETHER DTC OUTPUT RECURS |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds.
Start the engine and idle it for 30 seconds.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Check the DTCs output on the GTS.
| NEXT | |
| 7.INSPECT INJECTOR DRIVER |
![]() |
Disconnect the injector assembly connectors for all cylinders.
Start the engine.
Check the waveform of the injector assembly connectors using an oscilloscope.
| Tester Connection | Condition | Specified Condition |
| F31-3 (#1) - F31-6 (#10) | Cranking | Voltage increases by 50 V or more |
| F32-3 (#2) - F32-6 (#20) | Cranking | Voltage increases by 50 V or more |
| F33-3 (#3) - F33-6 (#30) | Cranking | Voltage increases by 50 V or more |
| F34-3 (#4) - F34-6 (#40) | Cranking | Voltage increases by 50 V or more |
| *a | Front view of wire harness connector (to Fuel Injector) |
|
| ||||
| OK | |
| 8.REPLACE INJECTOR ASSEMBLY (RELEVANT CYLINDER) |
Replace the injector assembly of the cylinder relevant to the DTC (Click here).
| NEXT | |
| 9.BLEED AIR FROM FUEL SYSTEM |
Bleed the air from the fuel system .
|
| ||||
| 10.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 11.CHECK HARNESS AND CONNECTOR (INJECTOR ASSEMBLY - INJECTOR DRIVER) |
Disconnect the injector assembly connectors.
Disconnect the injector driver connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F31-6 (#10) - I18-1 (IJ1+) | Always | Below 1 Ω |
| F31-3 (#1) - I18-4 (IJ1-) | Always | Below 1 Ω |
| F32-6 (#20) - I18-3 (IJ2+) | Always | Below 1 Ω |
| F32-3 (#2) - I18-6 (IJ2-) | Always | Below 1 Ω |
| F33-6 (#30) - I17-1 (IJ3+) | Always | Below 1 Ω |
| F33-3 (#3) - I17-3 (IJ3-) | Always | Below 1 Ω |
| F34-6 (#40) - I18-2 (IJ4+) | Always | Below 1 Ω |
| F34-3 (#4) - I18-5 (IJ4-) | Always | Below 1 Ω |
| F31-6 (#10) or I18-1 (IJ1+) - Body ground | Always | 10 kΩ or higher |
| F31-3 (#1) or I18-4 (IJ1-) - Body ground | Always | 10 kΩ or higher |
| F32-6 (#20) or I18-3 (IJ2+) - Body ground | Always | 10 kΩ or higher |
| F32-3 (#2) or I18-6 (IJ2-) - Body ground | Always | 10 kΩ or higher |
| F33-6 (#30) or I17-1 (IJ3+) - Body ground | Always | 10 kΩ or higher |
| F33-3 (#3) or I17-3 (IJ3-) - Body ground | Always | 10 kΩ or higher |
| F34-6 (#40) or I18-2 (IJ4+) - Body ground | Always | 10 kΩ or higher |
| F34-3 (#4) or I18-5 (IJ4-) - Body ground | Always | 10 kΩ or higher |
Reconnect the injector assembly connectors.
Reconnect the injector driver connectors.
|
| ||||
| OK | |
| 12.REPLACE INJECTOR DRIVER |
Replace the injector driver (Click here).
|
| ||||
| 13.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 14.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the GTS to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds or more.
Start the engine and idle it for 5 seconds.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| NEXT | ||
| ||