Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Ignition Switch Circuit


DESCRIPTION

When the ignition switch assembly is turned to ON, voltage is applied to terminal IG of the theft warning ECU assembly.

WIRING DIAGRAM


B278733E04


INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. When replacing the theft warning ECU assembly, refer to the registration procedures (Click here).

1.INSPECT IGNITION SWITCH ASSEMBLY


    B275965E01
  1. Remove the ignition switch assembly.

    1. for 1GR-FE: Click here
    2. for 2TR-FE: Click here
    3. for 2TR-FBE: Click here
    4. for 1KD-FTV: Click here
    5. for 2KD-FTV: Click here

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (IG1) - 4 (AM1)
    Off, ACC
    10 kΩ or higher
    1 (IG1) - 4 (AM1)
    ON, Start
    Below 1 Ω

    HINT:
    If replacing the ignition switch assembly, refer to the procedures below.
    1. for 1GR-FE: Click here
    2. for 2TR-FE: Click here
    3. for 2TR-FBE: Click here
    4. for 1KD-FTV: Click here
    5. for 2KD-FTV: Click here



NG
REPLACE IGNITION SWITCH ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - BATTERY AND BODY GROUND)
B274165E09
  1. Disconnect the T33 theft warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T33-1 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    T33-18 (IG) - Body ground
    Ignition switch Off
    Below 1 V
    T33-18 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Theft Warning ECU Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY