DTC C1436 Yaw Rate Sensor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1436 | Either condition is met:
| Yaw rate sensor assembly |
| 1.READ VALUE USING INTELLIGENT TESTER (YAW RATE SENSOR, YAW RATE SENSOR 2) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Yaw Rate Sensor | Yaw rate sensor / Min.: -128°/s, Max.: 127°/s | Vehicle stationary: 0°/s Right turn: -128 to 0°/s Left turn: 0 to 127°/s | - |
| Yaw Rate Sensor2 | Yaw rate sensor 2 / Min.: -128°/s, Max.: 127°/s | Vehicle stationary: 0°/s Right turn: -128 to 0°/s Left turn: 0 to 127°/s | - |
Check the yaw rate sensor output value displayed on the intelligent tester.
| Result | Proceed to |
| NG (Yaw rate sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning) | A |
| NG (Yaw rate sensor output value is not 0°/s when vehicle is stationary) | B |
| OK | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK YAW RATE SENSOR ASSEMBLY INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate sensor assembly is installed properly (Click here).
|
| ||||
| OK | ||
| ||