TOYOTA PARKING ASSIST-SENSOR SYSTEM > Back Sonar Sensor Circuit |

| 1.CHECK CLEARANCE WARNING ECU ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C25-22 (E2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| C25-24 (BOR) - C25-22 (E2) | Ignition switch ON, back sonar or clearance sonar switch on | 7.2 to 8.8 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - NO. 1 ULTRASONIC SENSOR RH) |
![]() |
Disconnect the C25 clearance warning ECU connector.
![]() |
Disconnect the U3 No. 1 ultrasonic sensor RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C25-24 (BOR) - U3-1 (BI) | Always | Below 1 Ω |
| C25-6 (SOR) - U3-3 (SI) | Always | Below 1 Ω |
| C25-22 (E2) - U3-5 (EI) | Always | Below 1 Ω |
| C25-24 (BOR) - Body ground | Always | 10 kΩ or higher |
| C25-6 (SOR) - Body ground | Always | 10 kΩ or higher |
| C25-22 (E2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NO. 1 ULTRASONIC SENSOR RH - NO. 1 ULTRASONIC SENSOR LH) |
![]() |
Disconnect the U3 No. 1 ultrasonic sensor RH connector.
![]() |
Disconnect the U2 No. 1 ultrasonic sensor LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U3-2 (BO) - U2-1 (BI) | Always | Below 1 Ω |
| U3-4 (SO) - U2-3 (SI) | Always | Below 1 Ω |
| U3-6 (EO) - U2-5 (EI) | Always | Below 1 Ω |
| U3-2 (BO) - Body ground | Always | 10 kΩ or higher |
| U3-4 (SO) - Body ground | Always | 10 kΩ or higher |
| U3-6 (EO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT NO. 1 ULTRASONIC SENSOR RH |
![]() |
Remove the No. 1 ultrasonic sensor RH (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (BI) - 5 (EI) | Always | 10 kΩ or higher |
| 1 (BI) - 2 (BO) | Always | 10 kΩ or higher |
| 3 (SI) - 4 (SO) | Always | Below 1 Ω |
| 5 (EI) - 6 (EO) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK TOYOTA PARKING ASSIST-SENSOR SYSTEM |
Check the operation of the TOYOTA parking assist-sensor system (Click here).
| Result | Proceed to |
| TOYOTA parking assist-sensor system malfunction | A |
| TOYOTA parking assist-sensor system normal operation | B |
|
| ||||
| A | |
| 6.REPLACE NO. 1 ULTRASONIC SENSOR LH |
Replace the No. 1 ultrasonic sensor LH (Click here).
| NEXT | |
| 7.CHECK TOYOTA PARKING ASSIST-SENSOR SYSTEM |
Check the operation of the TOYOTA parking assist-sensor system (Click here).
| Result | Proceed to |
| TOYOTA parking assist-sensor system malfunction | A |
| TOYOTA parking assist-sensor system normal operation | B |
|
| ||||
| A | |
| 8.REPLACE NO. 1 ULTRASONIC SENSOR RH |
Replace the No. 1 ultrasonic sensor RH (Click here).
| NEXT | |
| 9.CHECK TOYOTA PARKING ASSIST-SENSOR SYSTEM |
Check the operation of the TOYOTA parking assist-sensor system (Click here).
| Result | Proceed to |
| TOYOTA parking assist-sensor system malfunction | A |
| TOYOTA parking assist-sensor system normal operation | B |
|
| ||||
| A | ||
| ||