Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY
RM33K0E _59 Vehicle Exterior _043562 LIGHTING (EXT) _0219495 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 81560 1.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

a.
E319870C01
0,0 0,0 false
V113147

Slide in this Direction
V100155

Protective Tape


Slide the rear combination light assembly LH towards the vehicle front to attach the pin and guide.


b.

Install the 2 screws.


c.
E322670

Pass the wire harness into the vehicle and connect the grommet.


d.

Attach the wire harness clamp.


e.

Place your hand between the quarter inside trim board LH and the body to connect the connector.


Hide 62512 2.CONNECT QUARTER INSIDE TRIM BOARD LH

Hide 73233B 3.INSTALL REAR NO. 2 SEAT OUTER LAP BELT ANCHOR COVER

Hide 67935 4.INSTALL BACK DOOR SCUFF PLATE

Hide 5.INSTALL REAR NO. 2 SEAT ASSEMBLY LH

Hide 52159 6.INSTALL REAR BUMPER COVER