The following procedures are for BD22 (w/ Differential Lock).
41110
1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
Clean the contact surfaces of the rear differential carrier assembly and axle housing.
Install the rear differential carrier assembly and a new rear differential carrier gasket with the 10 nuts and 10 washers.
The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.
Do not damage the installation surface when installing the rear differential carrier assembly.
The remaining oil may leak out when installing the rear differential carrier assembly.
Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.
Install the bolts with the rear differential carrier assembly secured.
Connect the 2 connectors.
2.INSTALL DIFFERENTIAL PROTECTOR
Install the differential protector with the 2 bolts.
3.INSTALL REAR AXLE SHAFT WITH BACKING PLATE LH
for Rear Disc Brake
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT(for Rear Disc Brake)>INSTALLATION
for Rear Drum Brake
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT(for Rear Drum Brake)>INSTALLATION
4.INSTALL REAR AXLE SHAFT WITH BACKING PLATE RH
Use the same procedure described for the LH side.
37110F
5.INSTALL REAR PROPELLER SHAFT ASSEMBLY
6.ADD DIFFERENTIAL OIL
7.BLEED BRAKE SYSTEM
w/ VSC:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(w/ VSC)>BLEEDING
w/o VSC:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(w/o VSC)>BLEEDING
8.ADJUST PARKING BRAKE
9.INSTALL REAR WHEEL
10.CHECK ABS SPEED SENSOR SIGNAL