Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55410C
3.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55900
4.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
84013A
5.REMOVE INTEGRATION PANEL SUB-ASSEMBLY (for Manual Cooler System)
45287
6.REMOVE LOWER STEERING COLUMN COVER
55606
7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
73900
8.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
33504F
9.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
58804A
10.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
55407C
11.REMOVE LOWER INSTRUMENT COVER SUB-ASSEMBLY
84988H
12.REMOVE DOWNHILL ASSIST CONTROL SWITCH
|
Remove in this Direction |
Disconnect the downhill assist control switch connector.
Detach the 2 claws and remove the downhill assist control switch from the lower instrument cover sub-assembly.