Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM3250E _59 Vehicle Exterior _038077 DOOR / HATCH _0186364 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

HINT:
B276679C20
0.621,1.754 0.818,1.944 0.197,0.19 10 *1 2.535,1.754 2.732,1.944 0.197,0.19 10 *2
*1 Centering Bolt
*2 Standard Bolt


·

Centering bolts are used to mount the hood hinge to the vehicle body and hood. The hood cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts when making adjustments.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 53117C 1.REMOVE NO. 1 RADIATOR GRILLE RETAINER

Hide 53301 2.ADJUST HOOD SUB-ASSEMBLY

a.
B404414

Adjust the hood position.

i.

Loosen the 4 hinge bolts on the hood and adjust the hood position.


ii.

Move the hood and adjust the clearance between the hood and front fender.


iii.

Tighten the 4 hinge bolts on the hood after the adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.
B404415

Adjust the cushion rubbers so that the hood and fender are aligned.

HINT:

Raise or lower the front end of the hood by turning the cushion rubber.



c.
B404413

Adjust the hood lock.

i.

Loosen the 3 bolts.


ii.

Adjust the hood lock position so that the striker can enter it smoothly.


iii.

Tighten the 3 bolts after the adjustment.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)



Hide 53117C 3.INSTALL NO. 1 RADIATOR GRILLE RETAINER

Hide 53301 4.INSPECT HOOD SUB-ASSEMBLY