11381A
1.INSTALL REAR CRANKSHAFT OIL SEAL
Using SST and a hammer, tap in a new rear crankshaft oil seal until its surface is flush with the rear crankshaft oil seal retainer edge.
Apply MP grease to the lip of the rear crankshaft oil seal.
11381
2.INSTALL REAR CRANKSHAFT OIL SEAL RETAINER
Install a new gasket and the rear crankshaft oil seal retainer with the 4 bolts.
11301C
3.INSTALL FRONT CRANKSHAFT OIL SEAL
11301
4.INSTALL TIMING BELT CASE SUB-ASSEMBLY
15104
5.INSTALL OIL STRAINER SUB-ASSEMBLY
12101
6.INSTALL OIL PAN SUB-ASSEMBLY
13505
7.INSTALL NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
16100
8.INSTALL WATER PUMP ASSEMBLY
13502
9.INSTALL NO. 2 TIMING BELT IDLER SUB-ASSEMBLY
Install the spacer and No. 2 timing belt idler sub-assembly with the bolt.
Check that the No. 2 timing belt idler sub-assembly moves smoothly.
11115
10.INSTALL CYLINDER HEAD GASKET
11101
11.INSTALL CYLINDER HEAD SUB-ASSEMBLY
13511
12.INSTALL CAMSHAFT
11305A
13.INSTALL CAMSHAFT OIL SEAL
11385
14.INSTALL CAMSHAFT OIL SEAL RETAINER
11201
15.INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
Clean and degrease the contact surfaces of the cylinder head cover sub-assembly and cylinder head sub-assembly.
| *a | Seal Packing |
Apply seal packing to the specific areas shown in the illustration.
Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
Remove any oil from the contact surface.
Install the cylinder head cover sub-assembly within 3 minutes after applying seal packing.
Do not start the engine for at least 2 hours after installing the seal packing.
Install a new cylinder head cover gasket and the cylinder head cover sub-assembly to the cylinder head sub-assembly with the 9 bolts and nut.
12108
16.INSTALL OIL FILLER CAP SUB-ASSEMBLY
11322B
17.INSTALL NO. 2 TIMING BELT COVER
13523P
18.INSTALL CAMSHAFT TIMING PULLEY