Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2016.03
RM3250E _51 Engine / Hybrid System _038005 2GD-FTV ENGINE CONTROL _0192293 CRANKSHAFT POSITION SENSOR A

2GD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the crankshaft position sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


·

Engine starting

·

DTC P0630 is output


(Click here)
w/ DPF:(Click here)
w/ Urea SCR System:(Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.
Replacement of engine assembly
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting (Click here)
w/ DPF:(Click here)
w/ Urea SCR System:(Click here)
Clear Crank Time Compensation Data Engine starting (Click here)
w/ DPF:(Click here)
w/ Urea SCR System:(Click here)
for AC60E:

Replacement of automatic transmission assembly


Reset memory
·

Large shift shock

·

Engine overruns


(Click here)
for AC60E:

Replacement of automatic transmission fluid


ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
for AC60F:

Replacement of automatic transmission assembly


Reset memory
·

Large shift shock

·

Engine overruns


(Click here)
for AC60F:

Replacement of automatic transmission fluid


ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
w/ Automatic Headlight Beam Level Control System:

The vehicle height changes due to replacement of suspension components or after performing such operations as removal and reinstallation


Headlight leveling ECU assembly initialization Headlight leveling function (Click here)
for 4WD:

Front wheel alignment adjustment


·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


VSC malfunctioning (Click here)

PROCEDURE

Hide 31210 3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

Hide 31250 4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 13405 5.REMOVE FLYWHEEL SUB-ASSEMBLY

Hide 12581A 7.REMOVE NO. 1 CYLINDER BLOCK INSULATOR

Hide 12585 8.REMOVE NO. 5 CYLINDER BLOCK INSULATOR

Hide 27148C 9.REMOVE CONNECTING WIRE

a.
A346045

Disconnect the 2 connectors and clamp and remove the connecting wire.


Hide 10.REMOVE CRANKSHAFT POSITION SENSOR HARNESS BRACKET

a.
A346046

Remove the bolt and crankshaft position sensor harness bracket from the cylinder block sub-assembly.


Hide 11401Q 11.REMOVE CRANKSHAFT POSITION SENSOR

a.
A346047

Remove the bolt and crankshaft position sensor from the rear oil seal retainer.