Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › from 2016.03
RM3250E _56 Audio / Visual / Telematics _038052 AUDIO / VIDEO _0182784 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 86101J 1.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY

a.
E322711

w/ Digital Audio Broadcasting Antenna

i.

Attach the clamps to install the No. 2 antenna cord sub-assembly.


ii.

Connect the connectors.


iii.

Attach the guide and install the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)



b.
E322694

w/o Digital Audio Broadcasting Antenna

i.

Attach the clamps to install the No. 2 antenna cord sub-assembly.


ii.

Connect the connectors.



Hide 86101 3.INSTALL ANTENNA CORD SUB-ASSEMBLY (for LHD)

a.

w/ Navigation System:

i.

Install the antenna cord sub-assembly with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)

E322693


ii.

Attach the clamps shown in the illustration.


iii.

Connect the connector.



b.

w/o Navigation System:

i.

Install the antenna cord sub-assembly with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)

E322692


ii.

Attach the clamps shown in the illustration.


iii.

Connect the connector.



Hide 86101 4.INSTALL ANTENNA CORD SUB-ASSEMBLY (for RHD)

a.

w/ Navigation System:

i.

Install the antenna cord sub-assembly with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)

E310294


ii.

Attach the clamps shown in the illustration.


iii.

Connect the connector.



b.

w/o Navigation System:

i.

Install the antenna cord sub-assembly with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)

E310295


ii.

Attach the clamps shown in the illustration.


iii.

Connect the connector.



Hide 55302A 5.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).