1.REMOVE REAR WHEEL
42403
2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
46201E
3.REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY
4.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
for Single Cab:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL
5.REMOVE FRONT SEAT ASSEMBLY (for Bench Seat Type)
for Single Cab:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>REMOVAL
6.REMOVE REAR SEAT ASSEMBLY (for Double Cab)
64271C
7.REMOVE BACK PANEL TRIM (for Smart Cab)
67914B
8.REMOVE FRONT DOOR SCUFF PLATE LH
for Single Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Single Cab)>REMOVAL
for Smart Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Smart Cab)>REMOVAL
67913B
9.REMOVE FRONT DOOR SCUFF PLATE RH
for Single Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Single Cab)>REMOVAL
for Smart Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Smart Cab)>REMOVAL
67918E
10.REMOVE REAR DOOR SCUFF PLATE LH (for Double Cab)
67917C
11.REMOVE REAR DOOR SCUFF PLATE RH (for Double Cab)
73370C
12.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (for Double Cab)
73360C
13.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH (for Double Cab)
Use the same procedure described for the LH side.
62514A
14.REMOVE LOWER QUARTER TRIM PANEL LH
for Single Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Single Cab)>REMOVAL
for Smart Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Smart Cab)>REMOVAL
for Double Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>REMOVAL
62513A
15.REMOVE LOWER QUARTER TRIM PANEL RH
for Single Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Single Cab)>REMOVAL
for Smart Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Smart Cab)>REMOVAL
for Double Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>REMOVAL
58774A
16.REMOVE LUGGAGE COMPARTMENT SIDE COVER LH (for Smart Cab)
58773A
17.REMOVE LUGGAGE COMPARTMENT SIDE COVER RH (for Smart Cab)
46334
18.REMOVE INTERMEDIATE LEVER PROTECTOR
Partially remove the floor carpet.
It is not necessary to fully remove the floor carpet. Partially remove it so that the intermediate lever protector can be removed in a later step.
Remove the 3 bolts and intermediate lever protector with No. 2 console box mounting bracket.
| *A | for Single Cab | *B | except Single Cab |
58996A
19.REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET
Remove the 2 bolts and No. 2 console box mounting bracket from the intermediate lever protector.
| *A | for Single Cab | *B | except Single Cab |
46439
20.REMOVE PARKING BRAKE CABLE HEAT INSULATOR
Remove the 2 bolts and parking brake cable heat insulator.
51569
21.REMOVE PROPELLER SHAFT ASSEMBLY
22.REMOVE FUEL TANK
2KD-FTV:
Click hereEngine / Hybrid System>2KD-FTV FUEL>FUEL TANK>REMOVAL
2TR-FE:
Click hereEngine / Hybrid System>2TR-FE FUEL>FUEL TANK>REMOVAL
46410
23.REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY
Remove the 2 bolts (labeled A).
| *1 | No. 1 Parking Brake Cable Assembly | *2 | No. 2 Parking Brake Cable Assembly |
| *3 | No. 3 Parking Brake Cable Assembly | *4 | Parking Brake Equalizer Sub-assembly |
| *5 | Cable Support Bracket | - | - |
Remove the clip and pin from the No. 3 parking brake cable assembly.
Disconnect the No. 1 parking brake cable assembly from the No. 3 parking brake cable assembly.
Disconnect the No. 1 parking brake cable assembly from the parking brake equalizer sub-assembly.
Disconnect the No. 1 parking brake cable assembly from the cable support bracket.
Remove the No. 1 parking brake cable assembly from inside the vehicle.
Remove the bolt (labeled B) and cable support bracket.
46420
24.REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY
Disconnect the No. 2 parking brake cable assembly from the parking brake shoe lever.
Refer to the procedures up to the removal of the brake shoe.
Click hereBrake>BRAKE (REAR)>REAR BRAKE(for 2WD)>DISASSEMBLY
Remove the 2 bolts and disconnect the No. 2 parking brake cable assembly from the backing plate.
Disconnect the No. 2 parking brake cable assembly from the parking brake equalizer sub-assembly.
| *1 | No. 2 Parking Brake Cable Assembly | *2 | Parking Brake Equalizer Sub-assembly |
Remove the 4 bolts and No. 2 parking brake cable assembly.
46304
25.REMOVE PARKING BRAKE EQUALIZER SUB-ASSEMBLY
Remove the 2 bolts and parking brake equalizer sub-assembly.
46430
26.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Disconnect the No. 3 parking brake cable assembly from the parking brake shoe lever.
Refer to the procedures up to the removal of the brake shoe.
Click hereBrake>BRAKE (REAR)>REAR BRAKE(for 2WD)>DISASSEMBLY
Remove the 2 bolts and disconnect the No. 3 parking brake cable assembly from the backing plate.
Remove the clip.
| *1 | No. 3 Parking Brake Cable Assembly | - | - |
Remove the 4 bolts, nut and No. 3 parking brake cable assembly.