As the door control battery is installed between the vehicle battery and body ECU, first perform the inspections to confirm that there are no malfunctions in the power source circuit for the body ECU before performing this troubleshooting procedure.*1
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PRECAUTION
If the body ECU has been replaced, it is necessary to initialize the body ECU.*2
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
When replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.
*1: w/ Door Control Battery
*2: w/ Automatic Light Control System
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses, relays and bulbs related to this system before inspecting the suspected areas below.
*1: w/ Smart Entry and Start System
*2: w/ Immobiliser System
*3: for Single Cab
*4: for Smart Cab
*5: for Double Cab
*1: w/ Immobiliser System
*2: w/o Immobiliser System
| Symptom | Suspected Area | Link |
|---|---|---|
| Map light does not illuminate | Map light assembly |
|
| Harness or connector | - |
| Symptom | Suspected Area | Link |
|---|---|---|
| No. 1 room light does not illuminate | No. 1 room light assembly |
|
| Harness or connector | - |
| Symptom | Suspected Area | Link |
|---|---|---|
| No instrument panel illumination comes on | Lighting System (EXT) |
|
| Harness or connector | - |